38kHz Infrared (IR) Receiver TSOP1738 in Pakistan
₨20Highly sensitive, long transmission range
30KHz up to 56KHz carrier frequency
5mm IR LED Infrared TX / RX transmitter receiver Pair in Pakistan
₨20This is the 5mm IR Transmitter and Receiver pair matched pair used in our IR proximity, White Line or Micromouse sensor. It consists of 5mm 940 nanometer wave length high power IR LED and photodiode having peak sensitivity at 940 nanometer wavelength.
ABO-20L Transmitter and Receiver Active Beam Infrared Barrier Detector Photoelectric Motion Sensor ABO20L
₨3,350Model : ABO-20L
Theory : Current Sensor
Sensor : Receiver +Transmitter
Temperature : -25-55
Input : 12v
Out Put : Digital Sensor
Outdoor Distance: 10 Meter
Infra–Red Frequency: 1.92Khz
Product Size : 49.2*76*21.6mm
1X ABO-20L Transmitter and Receiver Active Beam Infrared Barrier Detector Photoelectric Sensor ABO20L
E27 Infrared Ceramic Heat Emitter Lamp Bulb for Reptile Pet Brooder – 100W
Original price was: ₨650.₨590Current price is: ₨590.Ceramic Heat Emitter
IR Sensor, IR Obstacle Detection Sensor Module in Pakistan
Original price was: ₨120.₨110Current price is: ₨110.- it consists of two tubes. one is transmitting and the second is receiving.
- it also has a green color indicator.
- it works on 3.3V to 5V level.
- it consists of three pins. VCC, GND, Output.
- its range is 2cm to 8cm.
Mini Infrared Digital Obstacle Avoidance Adjustable Sensor Module Board
₨380Mini Infrared Digital Obstacle Avoidance Sensor Module 3-100cm Adjustable 6mA Current Board
Smart Obstacle Avoidance Infrared Sensor Module Reflective Photoelectric Board
Omron DC 3 Wire DS10C4 10cm Infrared Ray Photoelectric Switch Sensor in Pakistan
₨1,120- Its manufacturer is OMRON.
- It is also known as a photoelectric switch.
- Its sending light in the form of infrared rays.
- Its type is DC 3 Wire NPN Normally Open.
- Its voltages are DC 10-30V.
- Its current is 200mA.
Photoelectric Module 5VDC IR Beam Counter in Pakistan
₨200Features:
It is using an imported groove optical coupling sensor and its width is 5mm.
It has an output in state light. If the output is on a high level, the light is off.
If the output is at a low level then the light is ON.
The output will be at a high level if it will be covered. And otherwise, its output level will low.
It has a good signal and waveform. It has a strong driving ability for more than 15mA.
It works on 3.3V to 5V.
It has a digital switch output of 0 and 1.
It is equipped with a fixed bolt hole and it is easily installed.
Its PCB size is 3.2cm x 1.4cm.
We can use LM393 wide voltage comparer.